Techna-Fit | Teflon Hose

Available in 3/6" or 1/4" and in a variety colors.

Advantages of Teflon

Chemical Resistant
PTFE is virtually unaffected to practically all commercial chemicals, acids, alcohols, coolants, elastomers, hydrocarbons, solvents, synthetic compounds and hydraulic fluids.
Temperature Resistant
It can handle it all, from cryogenics to steam all in one hose. Temperature range is from -65¡ F to 450¡ F
High Flow Rates & Low Friction
Due to the anti-stick properties of the Teflon¨ you will not experience low pressure drops from accumulate deposits on the inner core. Easy to clean permitting use of one hose for several services.
Flexible & Lightweight
Easier to move, handle and install than rubber hose with a comparable burst pressure rating. Withstands continuous flexing and vibration without failure from flex fatigue.
Moisture Resistant
No moisture absorption, ideal as a pigtail in bulk gas handling and pneumatic systems where a low dew point is critical.
Non-Adhesive
Handles substances such as adhesives, asphalt,dyes, greases, glue, latex, lacquers and paints with ease.
Chemically Inert
Will not break down or deteriorate in service.
Non-Aging
Impervious to weather and can be stored for extended periods of time without aging. It will not age during service.
Shock Resistant
Not affected by continuous flexing,vibration or impulse pressures - withstands alternating hot and cold cycling.

Polytetrafluoroethylene is an engineered fluoropolymer commonly known by DuPont's trade name "Teflon". Outstanding resistance to chemicals is one of it's primary attributes. A broad temperature range of -100F to 500F
(-73C to 260C) make this hose material suitable for the majority of fluid and ambient temperature conditions found in industry. An extremely low coefficient of friction, (0.05 to 0.20), provides a non-stick surface. Water absorption of PTFE is negligible, less than 0.01% by ASTM test. And, it is FDA-approved for food and pharmaceutical use.

Smooth Bore PTFE "Teflon" inner core Hose

Inner core vertically extruded to maintain highest quality concentricity.
Manufactured from DuPont's type 62 fine grade resin.
304 stainless steel wire braid reinforcement.
An exact amount of carbon black added to the PTFE inner core provides
continuous conductive path to the metal end fittings, to bleed off static
electricity in steam or high flow rate applications.

For continuous service: -65¡F to 450¡F (-54¡C to 232¡C)
For intermittent service: -100¡F to 500¡F (-73¡C to 260¡C)

Meets or exceeds requirements of SAE 100R14
PTFE meets FDA 21 CCFR 177.1550

Sizes -4 thru -10 are rated for full vacuum.
Larger sizes -12 and above can be reinforced with an internal support spring for
full vacuum service.

Physical Characteristics:

Tensile strength: 3,500 psi
Elongation: 250% min
Dielectric Strength: 1,000 volts per mil
Softening point: 500F (260C)